Hot Swapping Interface Modules; Hot Swapping The 10/100 Out Of Band Management Module; Hot Swapping The Management Module - Fortinet FortiGate FortiGate-4000 Installation Manual

Fortinet fortigate fortigate-4000: install guide
Hide thumbs Also See for FortiGate FortiGate-4000:
Table of Contents

Advertisement

Getting started

Hot swapping interface modules

Hot swapping the 10/100 out of band management module

Hot swapping the management module

FortiGate-4000 Installation Guide
This procedure describes how to hot swap a pass-through interface module or a
switched interface module.
For more information on these modules, see
page 24
and
"Switched interface module" on page 25
1
From the rear panel of the FortiGate-4000 chassis, loosen the two mounting knots
that fasten the pass-through interface module or the switched interface module that
you want to replace. Do not remove the mounting knots.
2
Do one of the following:
For the pass-through interface module, pull it out.
For the switched interface module, turn its power off and then pull it out.
3
Do one of the following:
Insert the new pass-through interface module into the chassis.
Insert the new switched interface module into the chassis, and turn on its power.
4
Tighten the mounting knots on the pass-through interface module or the switched
interface module.
Follow this procedure to hot swap a 10/100 out of band management module on the
rear panel of the FortiGate-4000 chassis.
For more information, see
1
From the rear panel of the FortiGate-4000 chassis, loosen the two mounting knots
that fasten the 10/100 out of band management that you want to replace. Do not
remove the mounting knots.
2
Pull the module out.
3
Insert the new switched interface module into the chassis.
4
Tighten the mounting knots on the module.
Follow this procedure to hot swap a management module on the rear panel of the
FortiGate-4000 chassis.
For more information on these modules, see
1
Power off the management module that you want to replace.
2
Unscrew the two locking screws to remove the module's locking strip.
3
Loosen its two mounting knots. Do not remove the mounting knots.
4
Pull out the management module.
5
Insert the new management module into the chassis.
6
Slide the management module into the slot until the lock clicks into place.
7
Screw the locking screws to fasten the locking strip.
8
Tighten the two mounting knots.
9
Turn on the power of the management module.
"10/100 out of band management module" on page
01-28004-0028-20040830
Hot swapping modules
"Pass-through interface module" on
respectively.
"Management module" on page
23.
22.
33

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FortiGate FortiGate-4000 and is the answer not in the manual?

Table of Contents

Save PDF