One-Way Tension Roller; Tape Leg Length; Leading Tape Leg Length Adjustment - 3M -Matic 8000a Instructions And Parts List

Adjustments

Tape Leg Length

Leading Tape Leg Length Adjustment –
Figure 5-6
The one-way tension roller position is
adjustable to control the leading tape
leg length.
Moving this roller farther away from
the box top or bottom surface will
decrease the leading leg length.
Moving it closer to the box top or
bottom surface will increase the
leading leg length.
Changing Tape Leg Length from 70 to
50mm [2 3/4-2 Inches] – Figure 5-7
Note – When changing tape leg length,
1. Remove and retain two hex head
2. Remount and secure brush in posi-
3. Remove cut-off bracket extensions
4. Remount cut-off bracket extensions
5. Remove/retain one-way tension roller
6. Remount tension roller assembly
7. Adjust tension roller according to
• To reduce the risk associated with
- Turn air and electrical supplies off
- Never attempt to work on the taping
3M-Matic Accuglide 3 - 3 Inch Taping Head
™
Page 16
(continued)
both upper and lower heads must be
adjusted to apply same leg lengths.
screws and remove the brush from
normal position "A" on side frame.
tion "A-A" on side frame forward of
normal location with original fasteners.
from position "B".
in forward position "B-B".
assembly from slot "C" in frame.
near top of slot "C-C" in frame using
original fasteners.

"Leading Tape Leg Length Adjustment"

above.
WARNING
shear, pinch, and entanglement hazards
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads
head or load tape while the box drive
system is running
Tape Leg 50 or 70mm ± 6mm
[2 or 2-3/4in. ± 1/4in.
Figure 5-6 Leading Tape Leg Length
Position A
Position A-A
Position B
Position B-B
Brush
Figure 5-7 Changing Tape Leg Length
WARNING
• To reduce the risk associated with sharp
blade hazards:
- Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp.
One-Way
Tension
Roller
Slot C-C
Slot C
Cut-Off Bracket
Extension
NA - ENG
April 2016