3M -Matic 8000a Instructions And Parts List page 47

13. Maintenance and Repairs
13.11
3M-Matic 8000a-8000a3
™
Page 35
Taping Heads (Refer to
Figure 13-5A, 13-5B, and 13-5C)
Note – Changing tape leg to
48mm [2 inches] requires
machine adjustment also.
See Manual 2 or 3
"Special Set-Up Procedure
Changing ape Leg Length".
1. Loosen, but do not remove, the two
retaining screws that secure upper
taping head shown - Figure 13-5A.
2. Hold upper taping head applying
and buffi ng arms from under upper
assembly, slide head forward and
down to remove Figure 13-5B.
3. Lift the lower taping head, shown in
Figure 13-5C, straight up to remove
it from the case sealer bed.
4. Refer to Manual 2 (Taping Head),
See "Adjustments – Changing Tape
Leg Length" for taping head set-up.
Figure 13-5 Removing Taping Heads From Case Sealer
(continued)
• To reduce the risk associated with
- Keep hands and fi ngers away from
Taping Head Adjustments
Tape Web Alignment
Tape Drum Friction Brake
Applying Mechanism Spring
One Way Tension Roller
Tape Leg Length
Leading Tape Leg Length Adjust – Manual 2
Changing Tape Leg Length from
70 to 48mm [2-3/4 to 2 inches] – Manual 2
B
C
WARNING
sharp blade hazards:
tape cutoff blades under orange blade
guards. The blades are extremely
sharp.
A
– Manual 2
– Manual 2
– Manual 2
– Manual 2
– Manual 2
NA - ENG
April 2016