3M -Matic 8000a Instructions And Parts List page 37

11. Set-Up and Adjustments
Figure 11-4
11.5 Special Set-Up Procedure for Outer Column Re-Positioning (continued on next page)
Moving the outer columns will increase/decrease the maximum box height capacity of the
8000a-8000a3 case sealer.
1. Place solid blocks approximately 12" [305mm] high at front and rear of upper taping
2. Crank the upper taping head assembly down until it touches these blocks.
3. Loosen (but do not remove) the eight (8) screws and washers that fasten each column to
Note: You will also need to loosen the two (2) set screws in the nut plate bracket (located
4. Turn height adjustment crank clockwise to raise outer columns until they reach the stop.
Note: Instructions are indicated for the Standard Column Position (Also see specifi cations).
5. Tighten the eight (8) screws and washers in each column.
A
305mm
Min.
3M-Matic 8000a-8000a3
™
Page 25
(continued)
B
head assembly as shown in Figure 11-7A.
the frame (Figure 11-7B).
above bottom two column screws).
If Alternate Column positions are needed, loosen and re-position the column stop.
Also tighten two Set Screws (if applicable)(continued on next page)
A
B
Figure 11-5
Figure 11-6
Note:
Loosen
but do not
Remove
Column
Screws
Figure 11-7
NA - ENG
April 2016