Removing The Mower Deck - Toro TimeCutter SW 4200 Operator's Manual

Removing the Mower Deck

1. Park the machine on a level surface and
disengage the blade-control switch.
2. Ensure that the parking brake is engaged, shut
off the engine, remove the key from the key
switch, and wait for all moving parts to stop
before leaving the operating position.
3. Lower the height-of-cut lever to the lowest
position.
4. Remove the hairpin-cotter pin from the front
support rod, and remove the rod from the deck
bracket (Figure 55).
Figure 55
1. Front support rod
2. Locknut
5. Carefully lower the front of the mower deck to
the ground.
6. Lift the mower deck and hanger brackets clear
of the rear lift rod and lower the mower carefully
to the ground (Figure
g014635
3. Deck bracket
56).
1. Mower deck
2. Hanger bracket
7. Slide the mower deck rearward to remove the
mower belt from the engine pulley.
8. Slide the mower deck out from underneath the
machine.
Note:
Retain all parts for future installation.
41
Figure 56
3. Rear lift rod
g005077