Transporting The Machine - Toro TimeCutter SW 4200 Operator's Manual

Figure 21
1. Bypass-lever locations
2. Lever position for
operating the machine
6. When finished, ensure that the key returns to
the position to avoid draining the battery
STOP
charge.
Note:
If the machine fails to move, the electric brake
may still be engaged. You can release the electric
brake manually if necessary; refer to
Electric Brake (page 35).
Operating the Machine
Move the bypass levers rearward through the keyhole
and down to lock them in place as shown in
Note:
Do this for each lever.
g017303
3. Lever position for pushing
the machine
Releasing the
Figure

Transporting the Machine

Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
necessary brakes, lighting, and marking as required
by law. Please carefully read all the safety instructions.
Knowing this information could help you, your family,
pets, or bystanders avoid injury.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents, causing personal
injury.
Do not drive the machine on a public street
or roadway.
1. If you are using a trailer, connect it to the towing
vehicle and connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Load the machine onto the trailer or truck.
4. Shut off the engine, remove the key from the key
switch, set the brake, and close the fuel valve.
5. Tie down the machine near the front caster
wheels and the rear bumper
21.
23
(Figure 22).
Figure 22
g027708