Loading The Machine - Toro TimeCutter SW 4200 Operator's Manual

Loading the Machine

Use extreme caution when loading or unloading
machines onto a trailer or a truck. Use a full-width
ramp that is wider than the machine for this procedure.
Back the machine up the ramp and drive it forward
down the ramp (Figure
Figure 23
1. Back the machine up the
ramp.
Important:
Do not use narrow individual ramps
for each side of the machine.
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death
• Use extreme caution when operating a
machine on a ramp.
• Use only a full-width ramp; do not use
individual ramps for each side of the
machine.
• Do not exceed a 15-degree angle between
the ramp and the ground or between the
ramp and the trailer or truck.
• Ensure that the length of ramp is at least
4 times as long as the height of the trailer
or truck bed to the ground. This ensures
that the ramp angle does not exceed 15
degrees on flat ground.
• Back the machine up the ramp and drive it
forward down the ramp.
• Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
23).
2. Drive the machine forward
down the ramp.
(Figure 24).
g028294
1. Full-width ramp in stowed
position
2. Side view of full-width
ramp in loading position
3. Not greater than
15 degrees
24
Figure 24
4. Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground
5. H=height of the trailer or
truck bed to the ground
6. Trailer
g027996