Toro TimeCutter SW 4200 Operator's Manual page 39

Figure 51
1. Blades side to side
2. Sail area of blade
5. Measure between the outside cutting edges
and the flat surface
measurements are not within 5 mm (3/16 inch),
an adjustment is required; continue with this
procedure.
6. Move to the left side of the machine.
7. Loosen the side locknut.
8. Raise or lower the left side of the mower deck
by rotating the rear nut.
Note:
Rotate the rear nut clockwise to
raise the mower deck; rotate the rear nut
counter-clockwise to lower the mower deck.
Figure 52
1. Hanger bracket
2. Side locknut
3. Outside cutting edges
4. Measure from the tip of the
blade to the flat surface
here
(Figure 51). If both
(Figure 52).
3. Rear locknut
9. Check the side-to-side adjustments again.
Repeat this procedure until the measurements
are correct.
10. Continue leveling the deck by checking the
front-to-rear blade slope; refer to
Front-to-Rear Blade Slope (page
g009682
g027588
39
Adjusting the
40).