Cleaning; Cleaning Under The Front Of The Machine; Washing The Underside Of The Mower Deck - Toro TimeCutter SW 4200 Operator's Manual

Cleaning

Cleaning under the Front of
the Machine
Service Interval: After each use—Check and clean
the front of the machine.
Remove debris under the front of the machine with
compressed air or by hand with a brush
Note:
Do not use water to clean under the front of the
machine, this can cause buildup of debris.
Figure 60
Washing the Underside of
the Mower Deck
Service Interval: After each use—Clean the
mower-deck housing.
Important:
You can wash the machine with a mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, under the seat, around the
engine, hydraulic pumps, and motors.
Wash the underside of the mower after each use to
prevent grass buildup for improved mulch action and
clipping dispersal.
1. Park the machine on a level surface and
disengage the blade-control switch.
2. Ensure that the parking brake is engaged, shut
off the engine, remove the key from the key
switch, and wait for all moving parts to stop
before leaving the operating position.
3. Attach the hose coupling to the end of the
mower washout fitting, and turn the water on
high (Figure 61).
Note:
Spread petroleum jelly on the washout
fitting O-ring to make the coupling slide on
easier and protect the O-ring.
(Figure 60).
1. Washout fitting
2. Hose
4.
5.
6.
g028248
7.
8.
9.
44
Figure 61
Lower the mower to the lowest height-of-cut.
Sit on the seat and start the engine.
Engage the blade-control switch and let the
mower run for 1 to 3 minutes.
Disengage the blade-control switch, shut off the
engine, remove the ignition key, and wait for all
moving parts to stop.
Turn the water off and remove the coupling from
the washout fitting.
Note:
If the mower is not clean after 1 washing,
soak it and let it stand for 30 minutes. Then,
repeat the process.
Run the mower again for 1 to 3 minutes to
remove excess water.
WARNING
A broken or missing washout fitting
could expose you and others to thrown
objects or blade contact. Contact with a
blade or thrown debris can cause injury
or death.
• Before you use the machine again,
immediately replace a broken or
missing washout fitting.
• Never put your hands or feet under
the mower or through openings in the
mower.
g020098
3. O-ring
4. Coupling