Table of Contents
Advertisement
Figure 69
1. Adjusting rod
2. Adjusting block
7.
To raise the front of the mower, tighten the
adjustment nut.
8.
To lower the front of the mower, loosen the
adjustment nut.
9.
After adjustment, check the front-to-rear slope
again, continue adjusting the nut until the front
blade tip is 1.6 to 7.9 mm (1/16 to 5/16 inch)
lower than the rear blade tip
Figure
68).
10.
When the front-to-rear blade slope is correct,
check the side-to-side level of the mower again;
refer to
Leveling from Side to Side (page
g014634
3. Locknut
(Figure 67
and
48).
Removing the Mower Deck
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Lower the height-of-cut lever to the lowest
position.
4.
Loosen the bottom 2 bolts holding the
mower-deck curtain to the mower deck. Refer to
Releasing the Mower-Deck Curtain (page
5.
Remove the hairpin cotter from the front support
rod, and remove the rod from the deck bracket
(Figure
70).
1. Front support rod
2. Locking nut
6.
Carefully lower the front of the mower deck to
the ground.
7.
Lift the mower deck and hanger brackets clear
of the rear lift rod and lower the mower carefully
to the ground
50
Figure 70
3. Deck bracket
(Figure
71).
34).
g014635
Advertisement
Table of Contents
