Drive System Maintenance; Checking The Tire Pressure; Releasing The Electric Brake - Toro TimeCutter SW 4200 Operator's Manual

Drive System
Maintenance

Checking the Tire Pressure

Service Interval: Every 25 hours—Check tire
pressure.
Maintain the air pressure in the front and rear tires as
specified. Uneven tire pressure can cause uneven
cut. Check the pressure at the valve stem
Check the tires when they are cold to get the most
accurate pressure reading.
Refer to the maximum pressure suggested by the tire
manufacturer on the sidewall of the caster wheel tires.
Inflate the rear drive wheel tires to 90 kPa (13 psi).
Figure 41
1. Valve stem
Releasing the Electric
Brake
You can manually disengage the electric brake by
rotating the link arms forward. Once the electric brake
is energized, the brake resets.
1. Turn the ignition key to the
disconnect the battery.
2. Locate the shaft on the electric brake where the
brake link arms are connected
(Figure 41).
3. Rotate the shaft forward to release the brake.
g000554
1. Brake-link arm on the electric brake control module
2. Left, rear tire
35
position or
OFF
(Figure 42).
Figure 42
g027911