Removing The Mower Deck - Toro 74732 Operator's Manual

Figure 58
1. Adjusting rod
2. Adjusting block
7. To raise the front of the mower, tighten the
adjustment nut.
8. To lower the front of the mower, loosen the
adjustment nut.
9. After adjustment, check the front-to-rear slope
again, continue adjusting the nut until the front
blade tip is 1.6 to 7.9 mm (1/16 to 5/16 inch)
lower than the rear blade tip
Figure 57).
10. When the front-to-rear blade slope is correct
check the side-to-side level of the mower again,
refer to Leveling from Side to Side (page
g014634
3. Locknut
(Figure 56 and
39).

Removing the Mower Deck

1. Park the machine on a level surface and
disengage the blade-control switch.
2. Move the motion-control levers outward to the
P position, shut off the engine, remove the
ARK
key, and wait for all moving parts to stop before
leaving the operating position.
3. Lower the height-of-cut lever to the lowest
position.
4. Remove the hairpin-cotter pin from the front
support rod, and remove the rod from the deck
bracket (Figure
1. Front support rod
2. Locking nut
5. Carefully lower the front of the mower deck to
the ground.
6. Lift the mower deck and hanger brackets clear
of the rear lift rod and lower the mower carefully
to the ground
41
59).
Figure 59
3. Deck bracket
(Figure 60).
g014635