Electrical System Maintenance; Electrical System Safety; Servicing The Battery - Toro TimeCutter SW 4200 Operator's Manual

Electrical System
Maintenance

Electrical System Safety

•
Disconnect the battery before repairing the
machine. Disconnect the negative terminal first
and the positive last. Connect the positive terminal
first and the negative last.
•
Charge the battery in an open, well-ventilated
area, away from sparks and flames. Unplug the
charger before connecting or disconnecting the
battery. Wear protective clothing and use insulated
tools.
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to
the State of California to cause
cancer and reproductive harm. Wash
hands after handling.

Servicing the Battery

Removing the Battery
WARNING
Battery terminals or metal tools could short
against metal machine components causing
sparks. Sparks can cause the battery gasses
to explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the machine.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
machine.
1. Park the machine on a level surface and
disengage the blade-control switch.
2. Ensure that the parking brake is engaged, shut
off the engine, remove the key from the key
switch, and wait for all moving parts to stop
before leaving the operating position.
3. Raise the seat to access the battery.
4. Disconnect the negative (black) ground cable
from the battery post
Note:
Retain all fasteners.
WARNING
Incorrect battery-cable routing could
damage the machine and cables, causing
sparks. Sparks can cause the battery
gasses to explode, resulting in personal
injury.
• Always disconnect the negative
(black) battery cable before
disconnecting the positive (red)
cable.
• Always connect the positive (red)
battery cable before connecting the
negative (black) cable.
5. Slide the rubber cover up the positive (red)
cable.
6. Disconnect the positive (red) cable from the
battery post (Figure
Note:
Retain all fasteners.
7. Remove the battery hold-down
lift the battery from the battery tray.
1. Battery
2. Positive (+) battery post
3. Bolt, washer, and nut
4. Terminal boot
33
(Figure 38).
38).
(Figure
Figure 38
5. Negative (–) battery post
6. Wing nut, washer, and bolt
7. Battery hold-down
38), and
g017701