After Operation; After Operation Safety; Pushing The Machine By Hand - Toro TimeCutter SW 4200 Operator's Manual

Alternating the Mowing Direction
Alternate the mowing direction to keep the grass
standing straight. This also helps disperse clippings
which enhances decomposition and fertilization.
Mowing at Correct Intervals
Grass grows at different rates at different times of
the year. To maintain the same cutting height, mow
more often in early spring. As the grass growth rate
slows in mid summer, mow less frequently. If you
cannot mow for an extended period, first mow at a
high cutting height, then mow again 2 days later at a
lower height setting.
Using a Slower Cutting Speed
To improve cut quality, use a slower ground speed
in certain conditions.
Avoiding Cutting Too Low
When mowing uneven turf, raise the cutting height
to avoid scalping the turf.
Stopping the Machine
If you must stop the forward motion of the machine
while mowing, a clump of grass clippings may
drop onto your lawn. To avoid this, move onto a
previously cut area with the blades engaged or you
can disengage the mower deck while moving forward.
Keeping the Underside of the
Mower Clean
Clean clippings and dirt from the underside of the
mower after each use. If grass and dirt build up inside
the mower, cutting quality will eventually become
unsatisfactory.
Maintaining the Blade(s)
Maintain a sharp blade throughout the cutting season
because a sharp blade cuts cleanly without tearing or
shredding the grass blades. Tearing and shredding
turns grass brown at the edges, which slows growth
and increases the chance of disease. Check the
mower blades after each use for sharpness, and
for any wear or damage. File down any nicks and
sharpen the blades as necessary. If a blade is
damaged or worn, replace it immediately with a
genuine Toro replacement blade.

After Operation

After Operation Safety

General Safety
•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
Shut off the fuel before storing or transporting the
machine.
•
Disengage the drive to the attachment whenever
you are transporting or not using the machine.
•
Use full-width ramps for loading the machine into
a trailer or truck.
•
Tie the machine down securely using straps,
chains, cable, or ropes. Both front and rear straps
should be directed down and outward from the
machine.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Pushing the Machine by
Hand
Important:
Always push the machine by hand. Do
not tow the machine, because damage may occur.
This machine has an electric-brake mechanism, and
to push the machine, the ignition key must be in
the position. The battery must be charged and
RUN
functioning for you to disengage the electric brake.
Pushing the Machine
1. Park the machine on a level surface, and
disengage the blade-control switch.
2. Engage the parking brake, shut off the engine,
and wait for all moving parts to stop before
leaving the operating position.
3. Locate the bypass levers on the frame on both
sides of the engine.
4. Move the bypass levers forward through the key
hole and down to lock them in place
Note:
Do this for each lever.
5. Turn the ignition key on and disengage the
parking brake.
Note:
Do not start the machine.
22
(Figure 21).