Toro TimeCutter SW 4200 Operator's Manual page 29

Checking the Engine-Oil Level
Service Interval: Before each use or daily—Check
the engine-oil level.
1. Park the machine on a level surface, disengage
the blade-control switch, shut off the engine, and
remove the key from the key switch.
2. Make sure that the engine is stopped, level,
and cool so that the oil has time to drain into
the sump.
3. Check the engine-oil level
Figure 30
(Figure 30).
g201307
29
Changing the Engine Oil and the
Engine-Oil Filter
Service Interval: Every 100 hours—Change the
engine oil and the engine-oil filter.
Note:
The drain plug is attached to the drain hose.
Note:
Dispose the used oil at a recycling center.
Fill with oil as specified in the table
1. Park the machine so that the drain side is slightly
lower than the opposite side to ensure that the
oil drains completely.
2. Disengage the blade-control switch and move
the motion-control levers outward to the P
position.
3. Shut off the engine, remove the key from the
key switch, and wait for all moving parts to stop
before leaving the operating position.
Figure 31
4. Torque the plug to 14 N·m (125 in-lb).
(Figure 29).
ARK
g027934