Preparing To Transfer The Printer - Canon TX-3000 Online Manual

Preparing to Transfer the Printer

To protect the internal parts in transit, always follow these steps before transferring the printer to a new
location.
For details on packing the printer and installing it after transfer, see
Important
• Be sure to contact your Canon dealer before transferring the printer to a new location. Ink may leak and
damage the printer if you do not prepare the printer correctly and it is tipped or stood on end in transit.
Note
• The maintenance cartridge needs to be replaced when you execute the Prepare to move menu.
Prepare the maintenance cartridge in advance while referring below. The number of maintenance
cartridge required varies depending on the amount remaining in the maintenance cartridge being used.
• If you can move the printer in a level state using casters or something similar, you do not need to
execute Prepare to move.
• Always follow the instructions of the service representative when preparing to transfer the printer.
The following lists transport restrictions by type of transport.
Move indoors on the same floor
Usage Examples: Move indoors by carrying
• Transport and storage in low temperature environments: No
• Permitted angle of inclination: All directions: within 30 °
• Required maintenance cartridges: 1-2
Move indoors to a different floor
Usage Examples: Moving the printer while temporarily tilting it such as when using the stairs
• Transport and storage in low temperature environments: No
• Permitted angle of inclination: All directions: within 90 °
• Required maintenance cartridges: 1-2
Transport outdoors
Usage Examples: Transport by vehicle
• Transport and storage in low temperature environments: Yes
• Permitted angle of inclination: All directions: within 90 °
• Required maintenance cartridges: 2
Preparing for Transportation
1. Remove the paper.
• Rolls
Removing the Upper Roll from the Printer
Removing the Lower Roll from the Roll Unit (Option)
• Sheet
Reinstalling the
472
Printer.