Canon TX-3000 Online Manual page 771

Changing the Print Quality and Correcting Image Data
Check if the print head is in the right position
Check 5
Adjust the print head position.
Automatic Adjustment to Straighten Lines and Colors
Color may be uneven if printing materials were stacked while drying
Check 6
To avoid uneven colors, we recommend drying each sheet separately.
Density may be uneven if using Glossy Paper or Coated Paper
Check 7
Set Print Quality to High, and then print.
Is the media type specified in the printer driver the same as the media type
Check 8
loaded in the printer?
Load paper of the same type as you have specified in the printer driver.
Loading the Upper Roll on the Printer
Loading Sheets in the Printer
Follow the steps below to match the media type in the printer driver to the media type loaded in the printer.
1. To stop printing, press the Stop button.
2. Change the type of paper in the printer driver and try printing again.
Is Ink drying target area for Pause between scans in the touch screen menu
Check 9
set to Leading edge?
If the Ink drying target area for Pause between scans is set to Leading edge, color may be uneven
approximately 4.3 to 6.3 inches (110 to 160 mm) from the front edge of the paper. (The position depends on the
Print Quality settings)
In this case, set Ink drying target area for Pause between scans to Overall.
However, note that printing will now take longer.
Menu Structure
(macOS)
771