Canon TX-3000 Online Manual page 68

• Be careful not to soil the printing surface of roll paper as you insert it in the slot. This may affect
the printing quality. We recommend wearing clean cloth gloves when handling rolls to protect the
printing surface.
• If the paper is wrinkled or warped, straighten it out before loading it.
• Load the roll so that there is no gap between the right edge of the paper and the Roll Holder.
• Depending on the paper, the roll paper may be scratched when being fed and not feed well. In this
case, you must feed the paper manually after setting Paper retention setting to Release on the
touch screen. Lift the release lever, advance the roll paper until its leading edge appears on
platen, lower the release lever, and then proceed to the next step. However, if Paper retention
setting is set to Release, automatic switching of the upper and lower rolls is not possible.
Once paper feeding starts, you will need to do the following, based on the Manage remaining roll
amount setting and the barcode printed on rolls. (See
Left.")
• When selecting Disable or Warning message in Manage remaining roll amount.
A menu for selecting the media type appears on the touch screen. Operate the touch screen and
select the media type to be used.
• When selecting Barcodes in Manage remaining roll amount and if the barcode is printed.
The type and amount of paper left is automatically detected based on the barcode printed on the
roll. There is no need to specify the type and length of the paper.
• When selecting Barcodes in Manage remaining roll amount and if the barcode is not
printed.
A menu for selection of the media type and length is shown on the touch screen. Operate the touch
screen, select the media type to be used, and enter its length.
Important
• When selecting Enable in Keep media type, there is no need to specify the type of the paper.
• Cut the edge of the roll using the Cut paper function if the edge is creased or soiled. (See
"Specifying the Cutting Method for
• When selecting the media type on the touch screen, make sure the media type set in the printer
driver and the media type loaded on the printer match.
"Keeping Track of the Amount of Roll Paper
Rolls.")
68