How to Switch Paper Rolls
Here we will explain how, in certain situations, paper roll 1 and paper roll 2 are switched. Refer to this
information when necessary, for example, when documents will not print as expected, etc.
If you select Roll Paper (Auto) under Paper Source in the Quality & Media, of the two paper rolls loaded
in the lower and upper trays of the printer, the one best suited for the print job will be automatically selected.
Whether paper roll 1 or paper roll 2 will be used, is determined through a sequence of judgment based on
the 7 conditions in the table below.
At such times, the Device settings -> Paper-related settings -> Detect paper setting mismatch in the
Printer unit's Control panel will switch to the result of the judgment based on the process described below.
•
If the Detect paper setting mismatch setting is set on Pause or Hold job
•
If the Detect paper setting mismatch setting is Display warning or Do not detect
Important
• If the lower roll unit is not loaded or if the roll unit that was set as the take-up unit is loaded, the roll
paper cannot be switched automatically.
Note
• If Error or On hold are displayed, replace the paper to match the requirements of the print job.
• In order to minimize paper waste, it is recommended that you configure the control panel on the
Printer unit as indicated below.
• In Device settings -> Paper-related settings, set Roll paper auto switching to Identify size
• In Paper settings display area -> (Each paper type) -> Paper settings -> Advanced, set
Detect paper width to Enable
If the Detect paper setting mismatch setting is set on Pause or Hold job
Whether the paper roll loaded on the printer is
Condi-
long enough to print the paper size specified for
tion 1
the print job.
Whether the paper roll loaded on the printer
Condi-
matches the paper type specified for the print
tion 2
job.
Condition
Situation
Only one of either paper roll 1 or
paper roll 2 is long enough
Neither paper roll 1 nor paper roll
2 are long enough
Both paper roll 1 and paper roll 2
are long enough
On the Printer's menu, Manage
remaining roll amount is set on
Disable (length of the paper roll
cannot be determined)
Only one of either paper roll 1 or
paper roll 2 matches the paper
type
554
Judgment result
Select the paper
roll of sufficient
length
Error
To Condition 2
Select the paper
roll matching the
paper type