Canon TX-3000 Online Manual page 60

Important
• If the roll paper has become unwound, remove the slack before loading the roll paper.
• When feeding the leading edge of the roll paper, make sure the entire width of the roll paper is
separating and feeding from the roll. If the roll paper is fed with some of the roll paper still
stuck to the roll, the roll paper will be damaged.
• Be careful not to soil the printing surface of roll paper as you insert it in the slot. This may
affect the printing quality. We recommend wearing clean cloth gloves when handling rolls to
protect the printing surface.
• If the paper is wrinkled or warped, straighten it out before loading it.
• Load the roll so that there is no gap between the right edge of the paper and the Roll Holder.
• Depending on the paper, the roll paper may be scratched when being fed and not feed well. In
this case, you must feed the paper manually after setting Paper retention setting to Release
on the touch screen. Lift the release lever, advance the roll paper until its leading edge
appears on platen, lower the release lever, and then proceed to the next step. However, if
60