Table of Contents
Advertisement
80
en | Appendices
May view duress alarm
May view alarm count
May view event memory
May view control panel history
May print control panel history
May view control panel version
Maintenance category permissions
May adjust control center volume/brightness
May change output state
May set date time
May test bell
May test motion detectors
May walk test automatic points
May walk test points
Tab. 8.5: Permissions
See also
–
–
8.2.11
Additional functions of the main panel
The panel has the following additional functions which do not have any influence on the
intended operation of the panel.
Point type technical, fire for alarm inputs
Inputs that are assigned the device Point can be programmed to the point type technical or
fire (refer to Point types and point evaluation, page 59).
Internal program
Points of the point type Intrusion can be assigned to an internal program.
When points are assigned to an internal program, and internal program is switched on, the
points are capable of alarm signaling in disarmed state.
If the detector is tripped, an internal alarm is generated.
This internal alarm results in only local alarm signaling without a remote alarm.
Outputs for individual applications
Outputs of the panel can be used to control individual applications. A prerequisite for this is
that no behavior item (no activation by the intended operation of the panel) is assigned to
such an output.
Manual output control
4
Automatic via schedule
1.
2.
2019-09 | 25 | F.01U.168.332
Installer button, page 66
Manufacturer authorization, page 59
Select Control Center > Behavior >Outputs Available For Direct Command.
Using the schedule wizard, enter the time when the output is to be switched on/off.
As action, select Output ON or Output OFF.
Installation manual
MAP 5000
X
X
X
X
X
X
X
X
X
X
X
X
1
2
3
X
X
X
X
X
X
X
X
X
X
X
Bosch Security Systems B.V.
4
Advertisement
Table of Contents
