Bosch MAP 5000 Series Installation Manual page 22

22 en | Installation
Figure 2.2: Putting the power supply warning label into the ICP-MAP0120 enclosure
4
Installing the AC terminal block
1.
2.
3.
2019-09 | 25 | F.01U.168.332
Refer to Technical Specifications, page 68 for power specifications.
Mount the AC terminal block to the enclosure back wall into the corresponding mounting
holes as shown in the figure below and secure it with the supplied screws (1).
Plug the terminal block connected to the AC terminal block into the power supply as
shown in the figure below (2).
Connect the ground wire to the ground connection point of the enclosure back wall as
shown in the figure below (3).
2
Installation manual
1
3
Bosch Security Systems B.V.
MAP 5000