Connecting The Power Supply - Bosch MAP 5000 Series Installation Manual

46 en | Connections
External BDB connector (1)
4
Programmable voltage outputs (2)
4
Programmable dry relay outputs (3)
4
Voltage output AUX (4)
4
Supervised inputs (5)
4
Input for panel tamper switch (6)
4
3.4

Connecting the power supply

1.
2.
Connecting the power supply
Connection Description
2019-09 | 25 | F.01U.168.332
Use this connection to connect additional system modules to the external BDB (refer to
Connecting the data bus, page 41 and Modules on the BDB, page 43).
Use these connections to control devices in certain system states (refer to Programmable
output signals, page 60).
Use these connections to control devices such as self-powered signaling devices in
certain system states (Programmable output signals, page 60).
Use this connection to supply voltage to devices in the panel. The voltage can be
switched on/off in certain system states.
Use these inputs to connect supervised conventional detectors or key switches RE = 12.1
KOhm (refer to Point types and point evaluation, page 59).
Use this input to connect the tamper switch of the panel (refer to Connecting the ICP-
MAP0050 tamper switch, page 53).
Connect the AC terminal block to the power supply.
Connect the power supply to the main panel using the supplied four-pin connector cable
(P/N: F01U074769).
1 1
2 2
Installation manual
MAP 5000
Bosch Security Systems B.V.