Replacing The Fan Module - Lenovo ThinkSystem NE1032 Installation Manual

Replacing the Fan Module

1. Select an empty fan module bay on the rear of the switch. If the target bay is
2. Remove the new fan module from the antistatic shielded bag.
3. Slide the fan module into the card guides in the open slot and gently push it all the
4. Tighten the retaining screw on the fan module. Torque the screw to approximately
5. Make sure that the fan module's LED is lit.
62
NE1032 Installation Guide
To replace a hot-swap fan module, complete the following steps:
covered by a blank fan filler plate, loosen the retainer screw and slide the filler plate
out of the slot.
way into the slot, so that it firmly engages with the connector (see the illustration).
Each fan module has a mechanical guide key to prevent you from inserting the
module incorrectly.
0.25 Nm +/- 0.1 Nm (2 inch-pounds).
Retainer Screw