Rj45 Management Port; Rj45 Management Leds; Reset Button - Lenovo ThinkSystem NE1032 Installation Manual

For lenovo cloud network operating system
Hide thumbs Also See for ThinkSystem NE1032:
Table of Contents

Advertisement

RJ45 Management Port

RJ45 Management LEDs

Reset Button

22
NE1032 Installation Guide
The RJ45 management port on the front panel supports 10/100/1000BASE-T, in-line
switch management.
To attach an RJ45 connector to the switch, push the RJ45 cable connector into the
port connector until it clicks into place.
To disconnect the RJ45 cable, squeeze the release tab and gently pull the cable
connector out of the switch connector.
The RJ45 management port LEDs are oriented as shown in the following figure.
Figure 5. RJ45 management port LEDs
Link LED
Status LEDs for the RJ45 management port are described in the following table.
Table 2.
RJ45 status LEDs behavior
LED
State
Link
Flashing green
Steady green
Off
Speed
Steady green
Off
The Reset button is recessed within a hole on the front panel. Use a straightened
paper clip or similar object to press the Reset button. The Reset button allows
technicians to reset the switch as follows:
Normal reset—press and release reset button. The switch will start a forced
reload procedure without saving the current configuration. This action is
intended for when the switch is unresponsive and needs to be restarted to
resume its normal functions.
Speed LED
Functional Meaning
Activity
Link up
No link
100/1000 Mbps connection
10 Mbps connection or no link

Advertisement

Table of Contents
loading

Table of Contents