Lenovo ThinkSystem NE1032 Installation Manual page 70

3. Set the new switch to use the Machine Type-Model (MTM) number of the old unit.
4. Set the new switch to use the serial number of the old unit. For example:
5. Reset the switch using the following command:
6. When prompted for confirmation, enter y. The switch will then restart.
7. After the switch reboots, return to the command prompt and verify that the VPD
70
NE1032 Installation Guide
For example:
NE1032(config)# hardware mtm 1234-56X
New MTM value: 1234-56X
Please reset the system for the new changes to take effect
where 1234-56X is the MTM from your old unit.
Note: The MTM shown here is merely an example. Use the actual MTM recorded
from your old NE1032 unit.
NE1032(config)# hardware esn XX01234567
where XX01234567 is the serial number of your old unit.
Note: The serial number shown here is merely an example. Use the actual serial
number recorded from your old NE1032 unit.
NE1032# reload
information is correct using the following command:
NE1032> display sys-info
*** display boot ***
Current ZTP State: Enable
Current FLASH software:
active image: version 10.4.2.0
standby image: version 10.4.2.0
Uboot: version 10.4.2.0
Currently set to boot software active image
Current port mode: default
Currently scheduled reboot time: none
...
System Name:
System Description:
System Model:
System Manufacture Date:
System Serial Number:
...
For more information about using the switch interface, see the Application Guide and
Command Reference for the NE1032 and its corresponding Lenovo Network
Operating System and firmware version.
NE1032
NE1032
LENOVO NE1032
1304
XX01234567