Xconfiguration Video Output Connector [1 - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction
xConfiguration Video Output Connector [1..2] MonitorRole
The monitor role describes which video streams will be shown on the monitor connected to this
video output connector. Together the Video Monitors setting and the MonitorRole settings for all
outputs define which layout (video streams) will be shown on each monitor.
Requires user role: ADMIN
Default value: Connector [1]: First Connector [2]: Second
USAGE:
xConfiguration Video Output Connector
where
n
: Unique ID that identifies the video output connector. Range: 1..2
MonitorRole
: Auto/First/Second/PresentationOnly
Auto: The system will detect when a monitor is connected, and a monitor role
(First, Second) that corresponds with the Video Monitors setting will be assigned
automatically.
First/Second: Define the role of the monitor in a multi-monitor setup. In a single-monitor
setup, there is no difference between First and Second.
PresentationOnly: Show presentation video stream if active, and nothing else. Monitors/
outputs with this monitor role are disregarded by the Video Monitors setting.
SX20 Codec API Reference Guide CE8.1, APRIL 2016.
D15316.03
About the API xConfiguration xConfiguration
n MonitorRole: MonitorRole
xCommand
xConfiguration Video Output Connector [1..2] OverscanLevel
Some monitors may not present the entire image that they receive. This means that the outer
parts of the image that is sent from the video system may be cut off when displayed on the
monitor.
Use this setting to instruct the video system not to use the outer part of the available frame.
This part might be cut off by the monitor. Both the video and messages on screen will be
scaled in this case.
Requires user role: ADMIN
Default value: None
USAGE:
xConfiguration Video Output Connector
where
n
: Unique ID that identifies the video output connector. Range: 1..2
OverscanLevel
: None/Medium/High
None: The video system will use all of the output resolution.
Medium: The video system will not use the outer 3% of the output resolution.
High: The video system will not use the outer 6% of the output resolution.
85
API Reference Guide
xStatus Appendices
n OverscanLevel: OverscanLevel
Copyright © 2016 Cisco Systems, Inc. All rights reserved.