Security Commands; Xcommand Security Persistency; Standby Commands; Xcommand Standby Activate - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

Security commands

xCommand Security Persistency

Set the following features to persistent or non-persistent mode. In non-persistent mode
the information gathered by the specified feature does not persist a reboot of the system.
Persistent mode is the default. This command reboots the system.
Requires user role: ADMIN
USAGE:
xCommand Security Persistency Configurations:
CallHistory InternalLogging: InternalLogging
DHCP: DHCP ConfirmAndReboot: ConfirmAndReboot
where
Configurations: NonPersistent/Persistent
In non-persistent mode, all configurations are set back to default when the system
reboots.
CallHistory: NonPersistent/Persistent
In non-persistent mode call history is deleted when the system reboots.
InternalLogging: NonPersistent/Persistent
In non-persistent mode eventlog is deleted when the system reboots.
LocalPhonebook: NonPersistent/Persistent
In non-persistent mode local phone book is deleted when the system reboots.
DHCP: NonPersistent/Persistent
In non-persistent mode all IP related information is deleted when the system reboots.
ConfirmAndReboot: Yes
Reboots the system.
SX20 Codec API Reference Guide CE8.1, APRIL 2016.
D15316.03
About the API xConfiguration
Configurations CallHistory:
LocalPhonebook: LocalPhonebook
xCommand xCommand

Standby commands

xCommand Standby Activate

Set the system in standby mode, which turns off the video outputs and put the camera into
sleep mode.
Requires user role: ADMIN, USER
USAGE:
xCommand Standby Activate

xCommand Standby Deactivate

Bring the system out of standby mode.
Requires user role: ADMIN, USER
USAGE:
xCommand Standby Deactivate

xCommand Standby ResetTimer

Set a temporary standby delay. If the system is in standby mode when the reset timer is set,
the system is brought out of standby mode. When left idle for the given delay the system goes
into standby mode. Setting the reset timer does not affect the Standby Delay in the Advanced
configuration menu (or by xConfiguration Standby Delay). Next time this delay is the valid
standby delay.
Requires user role: ADMIN, USER
USAGE:
xCommand Standby ResetTimer Delay:
where
Delay: Integer (1..480)
Set the delay in minutes.
117
API Reference Guide
xStatus Appendices
Delay
Copyright © 2016 Cisco Systems, Inc. All rights reserved.