WWW.SEAGULLMODELS.COM
3) Thread one clevis and M2 lock nut on
Nylon Snap Keeper.
to each elevator control rod. Thread the
horns on until they are flush with the
ends of the control rods.
4) Elevator and rudder pushrods assem-
bly as pictures below.
M2 clevis.
Elevator pushrod.
Fuel tubing.
Hex nut.
Pen.
RUDDER PUSHROD
INSTALLATION.
Repeat steps as same as steps done for
elevator.
M2 lock nut.
M2 clevis.
8mm
8mm
M2 lock nut.
M2 clevis.
8mm
.
23