The Initial Settings; Dynamic Ip Address Assignment; Static Ip Address Assignment - Datavideo DVK-300HD Instruction Manual

6. The Initial Settings

For proper operation, it is necessary to perform the initial setup of network parameters. Be
sure to provide reliable quality connection between the DVK-300HD and the PC on which the
control application is installed, in the case of firmware upgrade in particular. Please note that
all settings should be preserved during firmware upgrade.
• IP network address assigned by manufacturer: 192.168.1.10.
• The default device name is DataVideo ChromaKey
1. If you are working with a single device, you can connect it directly with a network cable.
PC running the application should be set to the IP address of the same subnet 192.168.1.X
(e.g. 192.168.1.5) as DVK-300HD.
2. If you are working with multiple DVK-300HD devices, it is possible to connect each device
with a network cable to the router. In this setup, the PC running the application should be
configured to the same subnet as the router to which the DVK-300HD devices are
connected.

6.1 Dynamic IP Address Assignment

After connecting the power and network cable, each of the devices by 30 seconds
automatically attempts to retrieve the IP address of the network in accordance with the
principle of dynamic IP allocation from your router. When it fails, the IP address of the device
is set to the default value (192.168.1.10). In this case, check the quality of the network cable
connections and repeat the procedure again by disconnecting and reconnecting the power
cord to the device.

6.2 Static IP Address Assignment

• Open the DVK-300HD Chroma Key application
• Select a device from the list of available devices
• Select the Configuration button located at the bottom right of the main window
• Select the Change button in the Network configuration
• Enter the IP address and subnet mask and click the Save button to complete the network
configuration
All manuals and user guides at all-guides.com
Network Configuration
11