Introduction; Ethernet; Typical Ethernet Straight-Through Cable Diagram For 10/100Base-T; Typical Ethernet Straight-Through Cable Diagram For 1000Base-T - Patton SmartNode 5540 Series User Manual

Enterprise session border controller, integrated access device, and voip gateway
Table of Contents

Advertisement

SmartNode 5540 & 4140 Series User Manual

Introduction

This section provides information on the cables used to connect the SmartNode device to the existing network
infrastructure and to third party products.

Ethernet

Ethernet devices (10/100/1000 Base-T) are connected to the SmartNode over a cable with RJ-45 plugs. All
Ethernet ports on the SmartNode device are Auto-MDX. Use any straight or crossover cable to a host, hubs,
switches, PCs or other devices.
CAUTION
Connecting both Ethernet ports to the same switch will only work if the
Note
switch has a separate ARP table for each connection.
Figure 16. Typical Ethernet straight-through cable diagram for 10/100Base-T
Figure 17. Typical Ethernet straight-through cable diagram for 1000Base-T

Introduction

The interconnecting cables shall be acceptable for external use
an shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
RJ-45, male
1
2
3
4
5
6
7
8
C • Cabling
RJ-45, male
1
2
3
4
5
6
7
8
55

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smartnode 4140 series13269d4-001

Table of Contents