Table of Contents
Advertisement
Voltage Conversion
to 220V
The voltage conversion MUST be performed by
an electrician or qualified service personnel.
The voltage conversion procedure consists of
rewiring the motor and installing the correct plug.
A wiring diagram is provided on Page 60 for your
reference.
IMPORTANT: If the diagram included on the
motor conflicts with the one on Page 60, the motor
may have changed since the manual was printed.
Use the diagram provided on the motor junction
box instead.
Items Needed
•
Phillips Head Screwdriver #2 ..................... 1
•
Electrical Tape ............................ As Needed
•
Wire Nut (16 AWG x 3) ............................... 1
•
6-15 Plug .................................................... 1
•
Wire Cutters/Stripper .................................. 1
To convert Model G0813/G0814 to 220V:
1.
DISCONNECT MACHINE FROM POWER!
2.
Cut off existing 5-15 plug.
3.
Open motor junction box, remove two wire
nuts indicated in Figure 7, then disconnect
wires.
To Switch
Remove
Wire
Nuts and
Disconnect
Wires
Figure 7. Inside motor junction box (motor pre-
wired to 120V).
Model G0813/G0814/G0814X (Mfd. Since 10/19)
4.
Use wire nuts to connect wires as indicated
in Figure 8. Twist wire nuts onto their respec-
tive wires and wrap them with electrical tape
so they will not come loose.
Connect Wires
and Secure
with Nuts
Qty
5.
Close and secure motor junction box.
6.
Install a 6-15 plug according to manufac-
turer's instructions. If plug manufacturer's
instructions are not available, NEMA stan-
dard 6-15 plug wiring is provided on Page 60.
Ground
To Switch
Figure 8. Motor rewired to 220V.
Ground
-17-
Advertisement
Table of Contents
