Grizzly G0813 Owner's Manual page 27

4. Attach each of the four corner supports to top
plate with (4) #10-24 x
shown in Figure 18. Ensure flange of each
support is installed inside top plate.
Corner
Support
Figure 18. Corner supports attached to top
plate.
5. Attach front and rear panels to corner sup-
ports with (7) #10-24 x
(see Figure 19). Orient panels upside down
so ON/OFF switch (front panel) and power
cord (rear panel) are at bottom.
Rear
Panel
Power
Cord
Motor
Cord
Figure 19. Front and rear panels attached to
corner supports.
Model G0813/G0814/G0814X (Mfd. Since 10/19)
⁄ " flange screws, as
3
8
x 4
⁄ " flange screws each
3
8
Front
Panel
ON/OFF
Switch
x 7
6. Attach motor cord and power cord wires to
ON/OFF switch terminals (see Figure 20).
Ensure motor cord wires attach to horizontal
terminals and power cord wires attach to ver-
tical terminals.
Horizontal Terminal
Motor Cord
GND
Power Cord
Horizontal
Terminal
GND
Motor
Cord
Figure 20. Wires connected to ON/OFF switch
terminals.
7. Attach switch box to front panel with (2) pre-
installed #10-24 x
Figure 21).
Switch Box
Figure 21. Switch box attached to front panel.
GND
Vertical
Terminal
Vertical
Terminal
GND
Power
Cord
⁄ " flange screws (see
3
8
Front
Panel
x 2
-25-