Grizzly G0813 Owner's Manual page 7

H
F
K
Figure 3. Cutterhead guard and depth-of-cut
scale.
H. Cutterhead Guard: Covers cutterhead
until pushed out of the way by workpiece
during operation. When workpiece leaves
cutterhead, guard springs back to its starting
position.
I. Depth-of-Cut Scale: Indicates cutting depth
of a single pass.
F. Outfeed Table Handwheel: Adjusts position
of outfeed table. Typically only used when set-
ting outfeed table even with cutterhead knives/
inserts or when servicing the cutterhead.
K. Outfeed Table Lock: Loosens to allow
adjustment of outfeed table height; tightens
to secure outfeed table.
Model G0813/G0814/G0814X (Mfd. Since 10/19)
I
L.
M. Swing Stop: When engaged, stops fence
N. 90° Fence Stop: When engaged, stops
O. 45° Fence Stop: Stops fence at 45° outward
P. Fence Tilt Lock: Secures fence tilt setting at
N
M
L
Figure 4. Fence controls.
Fence Lock: Loosens to allow adjustment of
fence position along width of tables. Tightens
to secure fence.
at 90°. When disengaged, allows fence to
adjust for bevel cuts.
fence at 90°.
Note: Even when fence stop bolt contacts
swing stop, tilt lock must be tightened before
starting machine.
Note: Swing stop must be disengaged for
bevel cuts greater than 90°.
(135°).
Note: Even when fence is resting against
stops, tilt lock must be tightened before start-
ing machine.
desired angle.
O
P
-5-