Table of Contents
Advertisement
Cutterhead guard must always return to
closed position whenever it is moved. If it
does not do this, it must be re-adjusted or
re-installed.
34. Test operation of guard by pulling it back.
Guard should spring back over cutterhead
and stop against fence.
— If guard does not snap back, or snaps
back slowly, remove guard and repeat
Steps 32–34.
35. Install belt guard with (1)
bolt and (1)
⁄
" flat washer (see Figure 38).
5
16
x 1
Figure 38. Belt guard installed.
-30-
⁄
"-18 x 2
⁄
" hex
5
1
16
2
36. G0813/G0814 Only: Assemble knife-setting
gauge, as shown in Figure 39.
Figure 39. Knife-setting gauge assembled.
37. Install dust port, as shown in Figure 40, using
(4) #10-24 x
⁄
" flange screws.
3
4
Figure 40. Dust port installed.
Model G0813/G0814/G0814X (Mfd. Since 10/19)
x 4
Advertisement
Table of Contents
