Table of Contents
Advertisement
Converting Voltage
to 220V
The voltage conversion MUST be performed by
an electrician or qualified service personnel. The
voltage conversion procedure consists of rewiring
the motor and transformer, and installing the cor-
rect plug. Wiring diagrams are provided on Pages
54–54 for your reference.
IMPORTANT: If the diagram included on the
motor conflicts with those on Pages 54–54, the
motor may have changed since the manual was
printed. Use the diagram included on the motor
instead.
Tools Needed:
•
Phillips Head Screwdriver #2 ..................... 1
•
Plug 6-15 .................................................... 1
•
Wire Cutters/Stripper .................................. 1
To convert machine to 220V:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove 110V switch and replace with 220V
switch (P0801405).
3.
Cut off existing 5-15 plug.
4.
Remove motor junction box cover, then
remove two jumpers, shown in Figure 8.
5.
Stack both jumpers and install them across
middle terminals, (see Figure 8), then make
sure all wires are securely installed in same
locations as they were when you started.
Jumper
Figure 8. Location of jumpers and middle
terminals inside motor junction box.
-16-
Qty
Middle
Terminals
Jumper
Tip: Although it is only necessary to install
one jumper across middle terminals, install-
ing both jumpers here prevents misplacing
the extra one in case you need it later to con-
vert machine back to 110V.
6.
Re-install motor junction box cover.
7.
Remove electrical panel access cover, then
locate transformer lower terminals and two
wires marked "L" and "N" (see Figures
9–10), then disconnect wire from 110V termi-
nal and connect it to 220V terminal.
Note: DO NOT move wire marked "N."
Transformer
Figure 9. Location of transformer lower
terminals.
24
TRANSFORMER
JBK5-63VA
INPUT: 100-220
OUTPUT: 24
220V
Terminal
220 110
L
Wires
Figure 10. Transformer wired for 110V.
8.
Re-install electrical panel access cover.
9.
Install a 6-15 plug on the power cord, accord-
ing to the plug manufacturer's instructions. If
the plug manufacturer's instructions are not
available.
Model G0801/G0802 (Mfd. Since 09/15)
Lower Terminals
0
110V
Terminal
0
PE
N
Advertisement
Table of Contents
