Table of Contents
Advertisement
8.
Remove motor junction box cover, loosen
strain relief, then insert motor cord into junc-
tion box, as shown in Figure 22.
9.
Attach ground wire with pre-installed ground
wire screw (see Figure 22).
Strain Relief
Wire Nut (1 of 2)
Figure 22. Inserting wires into junction box.
10. Remove wire nuts (see Figure 22) and dis-
connect wires, then use wire nuts to recon-
nect wires, as indicated in Figure 23. Twist
wire nuts onto their respective wires and
wrap them with electrical tape so they will not
come loose (see Figure 23).
To Switch
Connect
Wire Nuts
and Wires
Figure 23. Wires connected inside motor
junction box.
11. Make sure wires have enough slack between
strain relief and wire nuts so they are not
pulled tight or stretched, then tighten strain
relief against outer jacket of cord to secure it.
12. Test strain relief to ensure it is properly
tightened by pulling cord from outside junc-
tion box with light-to-moderate force. When
strain relief is properly tightened, cord will not
move inside junction box.
13. Re-install junction box cover.
-26-
14. Attach right panel to corner supports with (6)
Ground
Wire Screw
15. Attach left panel with dust chute to corner
Ground
16. Position mobile base chassis on stand so
Model G0813/G0814/G0814X (Mfd. Since 10/19)
#10-24 x
⁄
" flange screws (see Figure 24).
3
8
x 6
Figure 24. Right panel attached to stand.
supports using (6) #10-24 x
(see Figure 25).
x 6
Figure 25. Left panel attached to stand.
wheels are on same side as dust chute, then
secure base with (4)
3
⁄
" flat washers, and (4)
3
8
shown in Figure 26.
Chassis
x 4
Figure 26. Mobile base chassis attached to
stand.
Right
Panel
⁄
" flange screws
3
8
Left
Panel
⁄
"-16 x 1" hex bolts, (8)
8
⁄
"-16 hex nuts, as
3
8
Dust Chute
Advertisement
Table of Contents
