Table of Contents
Advertisement
17. Tighten all fasteners on stand.
18. G0814/G0814X Only: Turn stand upside
down and place top on flat surface.
19. Attach foot pedal caster assembly to side of
mobile base chassis with leveling feet, using
(2)
⁄
"-16 x 2
⁄
" hex bolts, (4)
3
1
8
2
ers, (2)
⁄
"-16 hex nuts, and (1)
3
8
hex bolt and (1)
⁄
5
16
Figure 27.
(Interior View)
x 1
Figure 27. Pedal assembly attached to right side
of stand.
20. Place stand in upright position and adjust lev-
eling feet as needed with hex nuts so stand
rests level and stable on floor.
21. Remove rear panel to access mounting holes
in stand during next step.
Model G0813/G0814/G0814X (Mfd. Since 10/19)
⁄
" flat wash-
3
8
⁄
"-18 x 2"
5
16
" flat washer, as shown in
x 2
22. With help of another person, place jointer
assembly onto stand. Attach jointer assembly
to stand with (3)
⁄
3
8
⁄
" flat washers (see Figure 28).
3
8
Note: Mounting requires reaching through
dust chute to install a hex bolt and washer on
left side of stand. Ensure cutterhead pulley is
positioned above slot in top of cabinet stand.
x 3
Figure 28. Jointer assembly attached to stand.
23. Place straightedge against pulleys to check
their alignment (see Figures 29–30).
— If pulleys are aligned, go to Step 25.
— If pulleys are not aligned, go to Step 24.
Straightedge
Figure 29. Checking belt alignment.
Cutterhead
Pulley
Alignment
Motor
Pulley
Figure 30. Pulley alignment.
"-16 x
⁄
" hex bolts and (3)
3
4
Slot
-27-
Advertisement
Table of Contents
