Strong SRT 8541 Installation Instructions Manual page 29

Problem
Scrambled channel
message
No response to the
remote control
Forgotten Parental
Control PIN code
Forgotten channel
lock code
After moving the
receiver to another
room/area you are no
longer able to receive
digital reception
The receiver switches
off automatically
Playback of video
causes picture freeze/
macro blocks or similar
distortion, especially on
HD content
Possible cause
Channel is scrambled
The receiver is off
The remote control is not aimed
correctly
The front panel is obstructed
The batteries of the remote
control are exhausted
The antenna signals are too weak
The signal strength/quality might
be less than before, if using an
indoor antenna
The Auto Standby function is
enabled
The read speed of your USB device
could be too low
What to do
Check if you have the rights to
watch this channel
Plug in the receiver, turn on the
plug and flick the power switch
ON.
Aim the remote control at the
front panel
Avoid obstructions
Replace the batteries of the
remote control
Default PIN is 0000
Contact your local Service Hotline
or send an email to our Support
via www.strong.tv
Press INFO on the remote control
to check the signal bars on
screen and adjust the antenna
for (maximum) reception.
Alternatively, do a rescan of the
channels.
When using an active antenna,
check if the antenna power
setting is On
Try using an outdoor antenna
Disable Auto Standby. See section
7.3.3.2 for details.
Make sure to use a USB storage
device with sufficient speed and
space. Pen drives ('USB sticks') may
not support sufficient speed.
25