Aerial Adjustment; Quick Guide To Using Your Receiver; Operation - Strong SRT 8541 Installation Instructions Manual

* Availability of DVB/HoH subtitles depends on the broadcast. If subtitles are not supported, they can be activated via
Teletext if available.
When all settings have been made, press the GREEN Next button to continue.

4.3 Aerial Adjustment

This part of the wizard is of great help when setting up your antenna system.
Use pq to move the highlight to the setting you wish to change and use t u to change values. The
following settings are available:
Antenna Power:
Channel No.:
When all settings have been made, press the GREEN Next button to start scanning.
The receiver will search for all available channels. When the scan is finished, the receiver switches to
viewing mode. Now you can enjoy watching your favourite TV channels. If you get the message "No
channels found", then check again the antenna, coaxial cable, connector and in menu if you have
reception. When this has been checked, reset the unit and follow the installation wizard again as
shown below.
NOTE:

5.0 QUICK GUIDE TO USING YOUR RECEIVER

We at STRONG understand that you can't wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We
do, however, advice you to read the full manual to get the best performance from your receiver.
Make sure the power switch on the back panel below the main power cord is turned ON. To turn your
receiver ON or to Standby, press q on the remote control or the button on the right hand side of the
front panel.
Choose the desired channel with pq. Alternatively, you can press the channel number with the 0~9
buttons on the remote control or press OK in viewing mode to display the channel list. The volume
can be adjusted with t u.

6.0 OPERATION

Your new receiver is equipped with several features to make watching TV a true pleasure. This
paragraph describes these features. Please do also read chapter 7.0 to get familiar with the menu of
your receiver.
10
Set to On if you use an active antenna (with built-in amplifier). When set to
On, 5 V will be present at the ANT IN connector of the receiver. Select Off for
passive antennas.
Select a channel that is known to carry a broadcast signal in your region.
The Signal Strength and Signal Quality bars give a visual indication of the
reception. Adjust your antenna to obtain maximum signal strength and
quality.
If the receiver won't start after switching on the receiver for the first time, reset
the receiver to factory settings by pressing the MENU button and selecting
Load Factory Setting in the menu Installation. (DEFAULT PIN: 0000).