Installing The Batteries; Using The Remote Control - Strong SRT 8541 Installation Instructions Manual

11. pq
12. t u
13. OK
14. MENU
15. 
16. VOL+/VOL-
17. P+/P-
18. LIST
19. CH+/CH-
20. OPT
21. TEXT
22. SUB
23. 
24. 2
25. 5 6
26. 4
27. u
28. 78
29. 3
30. COLOUR BUTTONS
* Subtitles, Videotext, EPG (Electronic Programme Guide), and Audio languages are depending on availability in the
specific broadcast
** This user manual describes the full functionality including the recording function and may not be applicable if the
software for recording via USB has not yet been installed (available in our web shop: www.strong.tv).

2.5 Installing the batteries

Open the cover on the remote control and insert 2x AAA type batteries into the compartment.
Observe correct polarity of the batteries when inserting. A terminal diagram is shown inside the
compartment.
1. Remove the cover.
2. Insert the batteries.
3. Place the cover.

2.6 Using the remote control

To use the remote control, point it towards the front of your receiver. The remote control supports a
range of up to 5 meters distance to the receiver at an angle of up to approx. 30 degrees.
Change channel to next/previous.
Menu: Moves the cursor up/down.
Decreases/increases the volume level.
Menu: Change settings for specific menus.
Opens the current channel list in menu: for confirmation
Opens the main menu, in a menu you will get one step back.
Exits from the menu or sub-menu.
Increases/decreases the volume level.
Page up/down in all list modes.
Call the current channel list.
Channel up/down.
Opens quick menu to adjust screen settings
Opens the Teletext* if available
Shows a list of subtitle* languages.
To read messages from your provider.
Hold play during playback/starting Timeshift mode**
Fast rewind/fast forward.
Starts recording of the currently watched programme**
Opens the multimedia menu
Jump function in multimedia playback
Stop playback.
In different menus for specific functions
Fig. 4
Fig. 5
7