Changing Channels; Info Banner; Selection Of Audio Language; Teletext - Strong SRT 8541 Installation Instructions Manual

6.1 Changing channels

Following ways are possible for changing channels with your new receiver:
Via direct access using the 0~9 buttons.
„ „
Via the channel list through OK and the PG+/PG- buttons.
„ „
Via the pq buttons.
„ „
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply enter its number with the 0~9 buttons on the
remote control. Channel numbers can be up to four digits long. Entering a number with less than
four digits is possible. Just wait a few seconds and your receiver will switch to the selected channel or
press OK immediately after selecting the channel number.
6.1.2 Channel list
Press OK in viewing mode to display the current TV list. Use pq in the channel list to highlight your
channel of choice and press OK to switch. Press OK again to leave the channel list mode. Inside the
channel list it is possible to use the PG+/PG- buttons as well in order to scroll page-wise through the
list to speed up.
6.1.3 Using
pq
p switches to the next channel.
q switches to the previous channel.

6.2 Info Banner

While watching TV, you can press INFO at any time to access information about the current channel
and event*. Press INFO twice for extended EPG details about the current channel. Press INFO three
times for EPG details of the next programme.
* Event information is displayed when available. Availability depends on broadcast.

6.3 Selection of audio language

Some channels support a choice of audio formats and/or languages.
To select another audio stream, press AUDIO in viewing mode. A list of available audio streams will
now be displayed. Use pq to select a stream and confirm with OK. The audio channel as stereo, mix,
left and right can be selected with t u.

6.4 Teletext

To access the available Videotext, press the TEXT button in viewing mode and use the 0~9 buttons
to enter the number of the page you wish to see. In case of availability you can also use the COLOUR
BUTTONS of the remote control for direct access, as indicated on the bottom of the screen.
Use pq to select one page up or down, use t u to select subpages. Press  or TEXT to get back to
viewing mode. While in TEXT mode, use the OK button to select the level of the teletext transparency
(five steps possible).
11