Network - Strong SRT 8541 Installation Instructions Manual

REC Icon:
* This user manual describes the full functionality including the recording function and may not be applicable if the
software for recording via USB has not yet been installed (available in our web shop: www.strong.tv).
7.4.3 Storage Device Setup*
This option shows relevant information about the connected USB device. In this menu, you can also
format your USB storage device and safely remove it.
Select Storage Device Setup in the Multimedia menu and press OK to enter.
Now you will see all details as free and used space sizes and used file system.
Press the RED Safely Remove button and press OK to safely disconnect the USB device. The receiver
will display a message indicating that you can now safely remove your storage device from the
receiver. Press the BLUE Format USB Device button to format the connected USB device.
Please, enter your PIN code to access this menu and press OK to start formatting.
Press  to leave this menu.
NOTE:
WARNING:
NOTE:
* This user manual describes the full functionality including the recording function and may not be applicable if the
software for recording via USB has not yet been installed (available in our web shop: www.strong.tv).

7.5 Network

This menu consists of the following submenus: RSS, Weather and IP Settings. First connect a CAT5E
(or higher quality) cable to the RJ-45 (ETHERNET) port of your receiver and ensure the other end
is connected to the internet accordingly. If there are questions or problems with the internet
connection, we recommend you to check details via the support or helpline of your internet provider.
Before you start to use the Internet functions please check the setup of the Internet connection
via IP Settings menu and confirm SET with OK. Usually the Internet connection should now been
established without any problem and ready to use. A message will inform you if the connection has
been setup successfully or not, use OK to confirm and press 9 to leave this menu.
22
If you start a recording, an icon will be shown in the left upper corner of
your TV screen with the text "REC". Default is set to On. Select 5 Seconds or 10
Seconds to let the icon disappear after the selected time.
After performing the Safely Remove function, the USB device is no longer
accessible by your receiver. To gain access to you're the storage device
again, re-insert it or switch the receiver to standby and on again.
Formatting will permanently delete ALL data stored on the connected
device. Please make a backup copy of all data you wish to keep before
entering the Format menu. STRONG cannot be held responsible for loss of
data from USB devices used with this receiver.
It is possible to use USB storage devices already formatted in NTFS.