Strong SRT 8541 Installation Instructions Manual page 18

7.1.1 Manual Search
This menu allows you to search for channels at a specific Frequency or Channel number.
Use pq to select Scan mode, and select between Free which will only install Free-to-Air channels or
All. This means that channels that are Free-to-Air or scrambled will be searched and stored.
Use pq to select Channel No and select the channel number of the frequency you'd like to search.
Press OK to open a list to make selection faster.
The next option Modulation is to select between Only DVB-T or DVB-T+T2 modulation type.
When in doubt, use the DVB-T+T2 setting.
If you use an active antenna (with built-in amplifier), then switch the Antenna Power to On. If you use a
passive antenna (without built-in amplifier), then select Off.
Highlight Search and press OK to start scanning. New found channels will be added to the channel
list.
7.1.2 Auto Search
This menu allows you to search for channels from all available Frequencies or Channel numbers. Be
aware that all previous installed channels and favourite list(s) will be deleted. The new found channels
will be installed in the channel list and afterwards you can create a new favourite list if you like.
Select Scan mode, and select between Free which will only install Free-to-Air channels or All. Highlight
Search and press OK to start scanning.
7.1.3 Information
This submenu shows receiver specific information such as hardware and software version. It also
displays technical information from the currently selected channel and signal strength and quality.
Please have the Information screen on hand when you call our hotline. The person who answers your
call might ask for the information given in this screen.
7.1.4 Load Factory Settings
This option allows you to reset the receiver back to the factory settings, which also clears all stored
channels.
Use pq to select Load Factory Settings in the Installation menu and press OK. You are asked to
enter your PIN code. Enter the correct PIN code using the 0~9 buttons. (DEFAULT PIN: 0000). A
confirmation window is displayed. Select OK to load factory settings. Select Cancel to cancel. Press 
to leave.
WARNING:
7.1.5 Freenet Menu
Read technical data about your subscription(s) and find messages from your provider. Moreover, you
can check the rights to watch certain programmes. A Software update is signalled here too. Follow
the instructions on screen. Some data given has no immediate meaning to a client, but is useful to
a service centre or provider itself. This menu gives access to the following submenus which can be
14
By resetting your receiver to factory default, all your settings and stored
channels will be permanently deleted. Please use this option with care.