Subtitles; Epg (Electronic Programme Guide); Record, Time Shift And Format - Strong SRT 8541 Installation Instructions Manual

6.5 Subtitles

Some channels support a choice of subtitle languages. Press SUB in viewing mode to display a list of
available subtitle languages. Select your subtitle of choice with pq and press OK to confirm. Press 
to leave without making changes.*
* Availability of DVB/Hard of Hearing subtitles depends on the broadcast. If subtitles are not present, they can be activated
via Teletext (if available).

6.6 EPG (Electronic Programme Guide)

The Electronic Programme Guide is a very useful function that allows you to view event schedules
and programme information and to mark events/movies for wakeup of the receiver. To access the
EPG, press EPG in viewing mode. Use pq to select a channel and t u to select an event. Press OK
to display detailed information of the selected event. Use 9 to quit the detailed information screen.
Press the RED or GREEN buttons to see and select another day. Press the YELLOW button to set a
timer for a selected event. Refer to section 7.3.4 for details of the timer function.
NOTE:

6.7 Record, Time shift and Format*

* This part of the user manual describes the full functionality including the recording function and may not be applicable
if the software for recording via USB has not yet been installed and activated. Please, visit our website www.strong.tv to
get more information.
To use these functions, you must connect a USB memory device to the USB port at the rear panel.
For best performance, especially of HD content, we advise to use Hard Disk Drives USB 2.0 or higher.
These must be formatted in FAT32 format otherwise Recording and Timeshift function will not work.
6.7.1 Instant recording*
To immediately record a programme, press 4 to start the recording and press 3 to quit.
6.7.2 Timeshift*
If you want to use the Timeshift function you only need to press 2 in viewing mode. To resume
timeshifted content, press u or 2 again. During the playback, you can use the 5 6 or 2 buttons. To
stop the Timeshift mode, press 3 and it will jump to the actual time of the live signal. The function will
still be running in the background and as long you do not switch to another channel it is possible to
jump again to the beginning by pressing 2 again. Also, with t u it is possible to jump in time during
Timeshift modes. Default is set to 20 seconds. Press the GREEN Jump Set button to change the jump
time.
If the channel is changed timeshifted content will only be accessible from the newly selected channel.
NOTE:
12
Availability of EPG data depends on broadcast.
To switch off the Timeshift function completely you need to change the
Timeshift status to disable in the Record setup menu.