Strong SRT 8541 Installation Instructions Manual page 25

Movies:
RED Subtitle:
GREEN Jump:
YELLOW Hide:
BLUE Audio:
Music:
pq:
Pictures:
pq:
RED Option:
* STRONG cannot guarantee the playback of files although extensions are listed, as it depends on codec, data bit rate and
resolution used (all MPEG codec formats are supported).
7.4.2 Record Setup*
This menu is only accessible if you connect a USB storage device. Here you can setup Timeshift and
recording.
The following settings are available:
Timeshift Status:
Timeshift Step:
Timeshift Duration:
Record Duration:
Start Record earlier:
End Record later:
During the playback of a movie with external subtitles, press the RED button
Subtitle to enter the subtitle menu. In this menu you can select size and
colours of your preference.
Press the GREEN button Jump to open the Jump By Time menu. You can
select a time where you'd like to jump to.
Press the YELLOW button Hide to remove or call the timeline information
banner.
Toggles between Stereo, Left, Right and Mono audio channel output.
Enter the folder with music files. Use the pq to select a file and press u or
OK to start playback. To stop playback press 3.
Enter the folder with picture files. Use pq to select a picture. If the format
is supported it shows the picture in the small picture-in-picture screen. Press
OK to watch it in full screen mode.
Before the playback of a picture in full screen, you can setup a slideshow/
diashow. Press the RED button Option to enter the sub option menu Slide
change Time. Select time of the slide show or switch this function off. After
you select a time, press OK and show starts to play. Press the  button to
stop.
Choose between Enable to activate the Timeshift function or Disable to switch
it off. This function will also automatically be set to Enable if you press 2 on
the remote and have USB device connected.
Select the time size step in minutes and seconds which you like to make by
using t u during navigation in Timeshift modes. Use the 0~9 buttons to
enter the time.
Select the maximal time (size) which is reserved for the Timeshift function.
Use the 0~9 buttons to enter the duration.
Select the default maximum time for recordings that can be started with the
4 button. Use the 0~9 buttons to enter the duration.
If you want to start the recording, set under timer from EPG some minutes
earlier than the time obtained from the programme guide.
If you want to stop the recording, set under timer from EPG some minutes
later as time obtained from the programme guide.
21