Your Receiver; Default Pin: 0000; Front Panel; Rear Panel - Strong SRT 8541 Installation Instructions Manual

2.0 YOUR RECEIVER

2.1 DEFAULT PIN: 0000

2.2 Front Panel

1. IR Sensor
2. LED Display
3. Mode Indicator LED
4. Standby/ON button
5. USB

2.3 Rear Panel

1. ANT IN
2. ETHERNET
3. HDMI
4. S/PDIF Coaxial
5. TV SCART
6. Power cord
7. Power switch

2.4 Remote control

1. q
2. !
3. 0~9
4. TV/R
5. 
6. FAV
7. 9
8. AUDIO
9. INFO
10. EPG
6
Receives commands from the remote control
Shows channel number and time in standby
RED indicates that the receiver is in STANDBY mode. GREEN
indicates that the receiver is in OPERATING mode.
Switches the receiver ON or into Standby
To connect your USB storage device.
To connect to your antenna for reception of broadcast signals.
To connect to your Ethernet cable (RJ-45) for RSS feeds and
weather forecasts
To connect your receiver with your TV-set using an HDMI cable.
To connect your receiver to a digital home cinema set, AV
receiver or digital audio amplifier.
To connect your receiver with your TV-set using a SCART cable.
Your receiver requires a supply voltage of 220 – 240 V AC
(Auto-selectable), 50/60Hz +/-5%. Please ensure the local power
specification meets these requirements before connecting your
receiver to the wall outlet.
To power your receiver ON or OFF
Switches the receiver On/Standby.
Quick press: passive standby – enables quick start-up. Long press
(more than one second): active standby - longer start-up time.
Mutes all audio outputs of the receiver
Enter channel number in TV mode or value input in menu
Toggles between TV or RADIO mode.
No function
Opens the favourite group selection.
One step back in menu or back to previous channel.
Opens the audio* language selection
Opens the current channel information; 2x opens the current
event information and 3x the next event information.*
Opens the EPG* (Electronic Programme Guide) in TV mode.
Fig. 1
Fig. 2
Fig. 3