Victory Motorcycles Hammer S Rider's Manual page 37

Electrical Components
Move the ignition switch to the ON position before performing the electrical inspections
outlined on this page. Return the ignition switch to the OFF position after completing these
inspections. If inspection of any electrical item reveals component failure, repair or replace
the component before operating the motorcycle.
Electrical Item
Headlamp
Taillight/Brake Light
Turn Signals
Emergency Flashers Press the top of the switch to activate the emergency flashers. Verify that all
Horn
Low Oil Pressure
Display
Neutral Indicator
Engine Stop/Run
Switch
Verify that the headlamp illuminates. Switch to high beam. Verify that the high
beam indicator comes on and that lamp brightness increases.
Verify that the taillight and license plate light illuminate. Verify that taillight
brightness increases when the front brake lever is applied and also when the
rear brake pedal is applied.
Move the turn signal switch to the left. Verify that front and rear left turn signals
flash, as well as the corresponding light on the indicator panel. Push the
switch inward to cancel the signal. Verify that the signals and the indicator light
stop flashing. Repeat the procedure for the right turn signals.
four turn signals flash, as well as the light on the indicator panel. Press the
bottom of the switch to cancel the flashers. Verify that all signals and indicators
stop flashing.
Press the horn button. Verify that the horn sounds loudly.
Start the engine. Verify that the low oil pressure display goes off in the multi-
function display.
Place the transmission in neutral. Verify that the neutral indicator comes on.
Start the engine. Move the stop/run switch to the STOP position. Verify that the
engine stops. Attempt to restart the engine to verify that the engine WILL NOT
start.
Pre-Ride Inspections
Inspection Procedure
35