Victory Motorcycles Hammer S Rider's Manual page 31

Instrument Cluster
Multi-Function Display
Engine Error Codes
The error screen displays only when the
CHECK ENGINE light is on or when it goes on
and off during one ignition cycle. Error codes
are not stored. When the key is turned OFF, the
code and message is lost, but will reappear if the
fault reoccurs after restarting the engine.
If the CHECK ENGINE indicator lamp
illuminates, retrieve the error codes from the
display.
1. If the error codes are not displayed, use the
mode button to toggle until "Ck ENG"
displays on the main line of the display.
2. Press and hold the mode button to enter the diagnostics code menu.
3. Record the three numbers displayed in the gear position, clock and odometer displays.
4. Press and release the mode button to advance to the next error code.
5. Press and hold the mode button to exit the diagnostics code menu.
6. See an authorized VICTORY dealer for code details and diagnosis.
Low Oil Pressure Display
"LO OIL" displays under the following
conditions.
Condition
Engine oil pressure has
dropped while the
engine is running.
The key is turned to
ON.
The stop/run switch is
moved to STOP.
Instruments, Features and Controls
Indicates
Oil pressure is below a
safe operating pressure.
The indicator circuit is
operating properly.
The system is operating
properly.
Error Code
Number (0-9)
Failure Mode Indicator (FMI)
Action Required
Stop the engine as soon as safely possible and
check the oil level. If the oil level is sufficient,
but "LO OIL" continues to display after restart-
ing the engine, stop the engine immediately.
Have your dealer check the oil pressure switch.
None - After two seconds the display will return
to the most recently active menu.
Press and release the MODE button to return
to the most recently active menu.
Suspect Parameter
Number (SPN)
29