Element4 Lucius 140 RD MKII Installation, Operation And Owner's Manual page 62

CONNECTING TO A SMART HOME SYSTEM (Smart Home System Cable)
G N
ENERAL OTES
The fireplace may be operated through an external source such as a smart home (home automation) system by using the 5-pin
connector on the receiver.
A required 39"/1000 cable, with connector, is available (part number E4-SA-SHSC-02). The overall cable length should not
mm
exceed 26'/8000 .
mm
Signal relays (gold contacts) or opto-couplers are recommended but not supplied. The E4-SA-SHSC-02 cable must be connected
to the three smart home system contacts as shown below.
You MUST ensure that the fireplace is in a safe and ready condition before attempting to operate from a remote source.
Element4 Gas Fireplaces
APPENDIX FOUR
E4-SA-SHSC-02
WARNING
SEqUENCE OF OPERATION
• To start ignition, close contacts 1 and 3 simultaneously
for 1 second.
• To set the valve to High Fire, close contact 1.
To set the valve to Pilot, close contact 3. In each case, the
contacts need to be closed for 12 seconds to turn the
motor from one end-stop to the other end stop.
• To set the valve to the Off position, close contacts 1, 2,
and 3 simultaneously for 1 second.
M
OdES OF OPERATION
• Mode 1 - the external source provides "ON" and "OFF"
operation only. The remote control handset provides all
other functions.
Note: Even if the fire is switched on by the external
source, the handset, in the thermostatic mode, controls
the room temperature. The room temperature setting of
the handset will remain the same for the next ON-cycle
of the external source as long as the temperature setting
in the handset has not been changed. If the handset is in
manual mode, it will go to High Fire in the next cycle of
external operation.
• Mode 2 - The handset must be set to the manual mode if
the external source is to control the room temperature.
If the handset is placed in the thermostatic mode it will
override the external source.
:
NOTE
Frequent ON and OFF cycles will limit life expectancy of the
valve and will increase battery consumption. The fireplace
should be powered by the AC adapter for improved
reliability and customer satisfaction.
62
EuropeanHome.com